Viewing equipment matching the following properties:
The EP 08 manual cutting press is designed for preparation of test specimens foremost of rubber and plastic materials by punching. (ISO527-2 5A)
The printer is capable of combining cells, growth factors and/or biomaterials to produce constructs using a pneumatic and mechanical syringe-based dispensing system. The printer is able to print in 6 axes, which allows you to accurately print contour
This ultra-fast handheld 3D scanner is easy to use and generates highly accurate and repeatable results—even in difficult environments and with complex surfaces.It is the very first device based on self-positioning handheld laser scanning technology
Chemical vapor deposition (CVD) represents a viable synthesis route to produce good-quality, large-area graphene films. In simple words, the technique relies on the thermal decomposition of a carbon-rich source and the further deposition of carbon at
Device consists of three automatic mercury intrusion porosimeters (two low pressure stations plus one high pressure station) achieving a maximum pressure of 33,000 psia for measurements in the range from over 950 micron to 0.0064 micron pore diameter
MC-780MAP provides a full body composition analysis with readings of medical character just within 20 seconds. Large, double LCD display shows body composition readings and segmental analysis in a user-friendly format.
Producing homogenous and conductive metal or carbon coatings for SEM and TEM analysis. Configured as a sputter coater or carbon thread evaporation coater, perfectly reproducible results can be achieved in the fully automated system. If both methods
Thermal conductivity analyser employs the modified transient plane source (MTPS) technique in characterizing the thermal conductivity (lambda) and effusivity of materials. It employs a one-sided, interfacial heat reflectance sensor that applies a mom
Geological cutting machine for sectioning of rock, ceramics, minerals, glass etc. with cutting capacity up to 250 mm in diameter.
The experimental flume HM 160 has a closed water circuit. The cross-section of the experimental section is 86x300mm. The experimental section is 2,5m long and can be increased to 5m with the extension element HM 160.10. The side walls of the experime
