Contacts and Location
Contact 1 | Uldis Sture |
---|---|
Enquire about this service | |
Organisational Unit |
Latvian Electronic Equipment Testing Centre (LEITC) - Latvia, Rīga |
Description
Accredited EMC testing, EMC pre-compliance testing and EMC troubleshooting to EMC compliance testing.
Specification
The equipment was set up as per the test configuration to simulate typical usage per user’s manual. When the EUT is a table top equipment, a wooden turntable with a height of 0,8m is used which is placed in a distance of 0,4m from vertical conductive plane. When EUT is floor standing equipment, it is placed on the 0,1m insulation support in a distance of 0,4m from vertical conductive plane. Auxiliary equipment and/or support equipment, if needed was placed as per EN 55022 recommendations. All input/output cables were positioned to simulate typical usage as per EN 55022. EUT mains power port was connected to LISN/AMN which is placed in a distance of 0,8m. Each EUT power lead, except ground (safety), was connected through a LISN/AMN to power source. All lines and neutral of power cord where measured. All telecommunication and signal cables are connected through ISN which is located in distance of 0,8m. Each cable lead is measured according to used connection type.
Service fields
measurement | - |
---|---|
testing | - |